FARGO electronic HDP700 - Manual (Page 141)

FARGO Electronics Inc.
A-16 HDP700 Series Card Printer
Figure A-5
The Firmware update will now take a few minutes. Check the printer's LCD for the status. When the
update is complete, the LCD will indicate if the update was successful. If "UPGRADE SUCCESSFUL"
is displayed, click Exit on the "Sending Update to Printer" dialog screen. Press the printer's EXIT
button. When prompted, turn the printer power OFF for a few seconds and then back ON to complete
the update process. As the printer restarts, you will see the new firmware version appear on the LCD.
If the upgrade was not successful, the LCD will display “UPGRADE FAILED” or “UPGRADE
FIRMWARE NOW
” on boot up. If you receive this message, try updating the firmware again.