FARGO electronic HDP700 User Manual
Page 34
FARGO Electronics Inc.
2-20
HDP700 Series Card Printer
2.9.9 Image Placement
Symptom: Printing is cut off or is not centered on the card, or a white border appears.
•
Verify that the HDP Film spools are wound evenly. If the spools are wound unevenly, replace the
roll of HDP Film.
•
Align the edge of the HDP Film with the Transfer Station’s red alignment arrows manually to
ensure the Film is tracking properly.
•
Verify that the Ribbon and Film are properly seated on both sides. The hubs’ axels should rotate as
you rotate the spool. If not, replace the hubs as described in Section 4.5.11.
•
Verify that the Dancer Rollers spin freely by opening the top and middle modules and manually
spinning the Dancer Rollers.
•
Confirm that the correct Card Size option is selected in the printer driver setup. Improper card
size settings will place the image in the wrong area of the card.
•
Confirm that the card is feeding straight into the print Section; if it is not, check to ensure that the
Card Size Knob in the base module is set to the proper card size.
•
Confirm that the Flattener is not impeding the card by manually feeding a card into the printer
using the FORWARD and BACK buttons on the display. The card should move freely under the
Flattener. If the card is hitting the Flattener, adjust the height of the Flattener by loosening the
two screws that hold the Flattener.
•
Verify that the upper and middle modules are seated properly and are completely locked down.