FARGO electronic HDP700 - Manual (Page 97)

FARGO Electronics Inc.
HDP700 Series Card Printer 4-39
4.8.3 Card Feed Belt
(220082)
Refer To Drawing 840156
Tools Needed
Phillips-head Screwdriver, Small Standard Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board
Assembly (140403).
4. Remove the five screws from the base of the Card Input Hopper Cover and remove the other
four screws from inside the print station.
5. Lift the Card Input Hopper Cover off of the printer.
6. Remove C-clip from the one-way pulley (840215)
7. Slip the Belt off of the Card Feed Pulley (840212).
8. Remove the pulley (840215) from the shaft
4.8.4 Cleaning Roller Drive Idler Gear — 2
(760401)
Refer To Drawing 840156
Tools Needed
Phillips-head Screwdriver, Small Standard Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board
Assembly (140403).
4. Remove the five screws from the base of the Card Input Hopper Cover and remove the other
four screws from inside the print station.
5. Lift the Card Input Hopper Cover off of the printer.
6. Remove the screws from the Back Cover of the printer.
7. Tilt the Back Cover outwards from the printer.
8. Remove the screws from the back plate and move it far enough to allow access to the back of
the hopper assembly.
9. Use the small standard screwdriver to remove the Retaining Ring (140062) from the Idler
Gear.
10. Slide the Idler Gear from the shaft.