FARGO electronic HDP700 - Manual (Page 81)

FARGO Electronics Inc.
HDP700 Series Card Printer 4-23
4.6 Replacing the Belt Driven Base Module Components
Follow the procedures in this Section to replace the Belt Driven Base Module components.
4.6.1 Drive Belt – Platen Roller to Card Feed Roller (Front)
(220071)
Refer To Drawing 840151
Tools Needed
Torx T-10 Screwdriver, Phillips-head Screwdriver, 1.5 mm Allen Wrench
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Bring the Transfer Station up and forward.
6. Remove the four screws (F000034) from the Front Transfer Station Cover.
7. Lift off the Front Transfer Station Cover.
8. Remove the two screws (F000034) from the bottom of the Base Module Cover.
9. Open the Door of the Card Input Hopper and the Card Output Hopper Door.
10. Remove the two screws (F000034) from each side of the Base Module Cover.
11. Rotate the Transfer Station to a 45° angle.
12. Pull the Base Module Cover carefully up and out of the printer.
13. Loosen the two Allen-head screws on the middle Pulley (F000006).
14. Take the Pulley from the shaft.
15. Remove the Belt from the printer.
NOTE
Ensure that the new Belt is pulled taut and securely in place; if the Belt is not tight, the printer will not
function properly.
4.6.2 Drive Belt – Card Feed Roller to Card Feed Roller
(220082)
Refer To Drawing 840151
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver, 1.5 mm Allen Wrench
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.