FARGO electronic HDP700 - Manual (Page 68)

FARGO Electronics Inc.
4-10 HDP700 Series Card Printer
10. Slide the Encoder Wheel gently off of the shaft.
11. Use the small standard screwdriver to remove the Retaining Ring (140061) from the Pulley
Gear Combo (760287).
12. Slide the Pulley Gear Combo from the shaft.
13. Remove the O-Ring.
4.4.2 Ribbon Sensor Board Assembly
(140407)
Refer To Drawing 840153
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Remove the four screws (F000034) from the Print Station Cover of the printer.
6. Lower the Print Station back into position.
7. Lift the Print Station Cover off of the printer.
8. Remove the two screws (130971) from the Sensor Board.
9. Disconnect the cable from the Sensor Board.
10. Remove the Sensor Board from the printer.
4.4.3 Encoder Wheel
(810492)
Refer To Drawing 840153
Tools Needed
Phillips-head Screwdriver, Small Standard Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Remove the four screws (F000034) from the Print Station Cover of the printer.
6. Lower the Print Station back into position.
7. Lift the Print Station Cover off of the printer.
8. Use the standard screwdriver to take the Retainer Clip (897144) from the Encoder Wheel.
9. Remove the Washer (130997) from the Encoder Wheel.