FARGO electronic HDP700 - Manual (Page 66)

FARGO Electronics Inc.
4-8 HDP700 Series Card Printer
7. Lift the Print Station Cover off of the printer.
8. Remove the two screws (F000169) that secure the Fan to the printer.
9. Unplug the cable connector.
10. Take the Fan Assembly from the printer.
4.3.3 Head Force Spring — 2
(840272)
Refer To Drawing 840160
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Remove the four screws (F000034) from the Print Station Cover of the printer.
6. Lower the Print Station back into position.
7. Lift the Print Station Cover off of the printer.
8. Stand at the front of the printer and locate the tab on the back right of the Printhead
(220252).
9. Push up on the tab and remove the Printhead.
10. Use a Torx T-10 screwdriver to remove the screw (F000172) from the Head Force Spring.
11. Remove the Head Force Spring from the printer.
4.3.4 Ribbon Deflector
(D840638)
Refer To Drawing 840160
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Remove the two screws (F000170).
6. Remove the Ribbon Deflector from the printer.