FARGO electronic HDP700 - Manual (Page 69)

FARGO Electronics Inc.
HDP700 Series Card Printer 4-11
4.4.4 Ribbon Sensor Array Assembly
(840108)
Refer To Drawing 840153
Tools Needed
Phillips-head Screwdriver, Small Standard Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Remove the four screws (F000034) from the Print Station Cover of the printer.
6. Lower the Print Station back into position.
7. Lift the Print Station Cover off of the printer.
8. Use the small standard screwdriver to remove the Retaining Ring (140061) from the Ribbon
Transfer Roller (840318) to allow for clearance.
9. Remove the screws (F000190) from each end of the Ribbon Sensor Array.
10. Remove the screws (F000190) from the top sides of the four 1x1 Cross Members (840239).
11. Take the Ribbon Sensor Array Assembly from the printer.
12. Disconnect the cable connector from the Ribbon Sensor Array Board.
4.4.5 Ribbon Supply Motor Assembly
(D840980)
Refer To Drawing 840153
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Remove the four screws (F000034) from the Print Station Cover of the printer.
6. Lower the Print Station back into position.
7. Lift the Print Station Cover off of the printer.
8. Stand at the back of the printer and Remove the two screws (F000169) that secure the
Ribbon Supply Motor Assembly.
9. Disconnect the cable connector.