FARGO electronic HDP700 - Manual (Page 26)

FARGO Electronics Inc.
2-12 HDP700 Series Card Printer
3. Press the CANCEL button to reboot the printer and cancel all jobs from the printer memory.
All current print jobs will be canceled and will need to be resent from the computer.
2.7.4 Temperature Timeout
• Run a self-test as described in Section 7.2. If no error occurs, the settings in driver may be too high
or too low. See Section 3.5 for instructions of how to adjust the transfer settings.
• The Transfer Roller is unable to reach the optimum temperature. Turn the printer OFF and ON to
reset, and try reprinting. If the problem persists, see Section 2.7.2 to test the Thermocouple.
2.7.5 Transfer Lift
The printer is unable to determine the placement of the Lamination Roller. Check to ensure that the
Transfer Lift Motor is running. Disconnect the motor from the Lamination Board. A 9 VDC battery
connected to the motors’ leads may be used for testing. If the motor does turn, replace the Transfer Lift
sensor as described in Section 4.5.13. If the motor does not turn, replace the Transfer Lift Motor as
described in Section 4.5.14.