FARGO electronic HDP700 - Manual (Page 61)

FARGO Electronics Inc.
HDP700 Series Card Printer 4-3
4.1 Removing the Covers
A cover, or a combination of covers, will need to be removed to access the part(s) to be replaced.
4.1.1 Print Station Cover
Refer To Drawing 840155
Tools Needed
Phillips-head Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Remove the four screws (F000034) from the Print Station Cover of the printer.
6. Lower the Print Station back into position.
7. Lift the Print Station Cover off of the printer.
4.1.2 Front Transfer Cover
Refer To Drawing 840155
Tools Needed
Phillips-head Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Bring the Transfer Station up and forward.
6. Remove the four screws (F000034) from the Front Cover.
7. Lift off the Front Cover.
4.1.3 Rear Transfer Cover
Refer To Drawing 840152
Tools Needed
Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Bring the Transfer Station up and forward.