FARGO electronic HDP700 - Manual (Page 94)

FARGO Electronics Inc.
4-36 HDP700 Series Card Printer
4.7.10 Compound Gear
(D841032)
Refer To Drawing 840151
Tools Needed
Torx T-10 Screwdriver, Standard Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Remove the screws from the Back Cover of the printer.
3. Tilt the Back Cover outwards from the printer.
4. Remove the four screws that secure the Rear Bracket (D840585) to the printer.
5. Detach the cables running to the board.
6. Remove the screw from the Gas Spring (840366) and take off the Washers (130283 and
140040).
7. Set the Back Cover carefully aside.
8. Remove the screw from the linkage.
9. Use the standard screwdriver to hold back the locking tab on the drive gear while pulling it
from the shaft.
10. Remove the gear from the printer
11. Remove the two screws from the stepper motor bracket.
12. Disconnect the cable connector.
13. Remove the Stepper Motor Assembly from the printer.
14. Use the standard screwdriver to remove the retaining clip.
15. Pull the Drive Gear from the printer.
4.7.11 Base Module
(840151)
Refer To Drawing 840151
Tools Needed
Torx T-10 Screwdriver, Standard Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Remove the screws from the Back Cover of the printer.
3. Tilt the Back Cover outwards from the printer.
4. Remove the four screws that secure the Rear Bracket (D840585) to the printer.
5. Detach the cables running to the boards.
6. Remove the screw from the Gas Spring (840366) and take off the Washers (130283 and
140040).
7. Set the Back Cover carefully aside.
8. Open the Front Access Door.