FARGO electronic HDP700 - Manual (Page 80)

FARGO Electronics Inc.
4-22 HDP700 Series Card Printer
3. Push the Release Lever down to unlock it.
4. Move the Print Station up and back
5. Bring the Transfer Station up and forward.
6. Remove the four screws (F000034) from the Front Cover.
7. Lift off the Front Cover.
8. Remove the two screws (F000034) from the Rear Transfer Cover.
9. Lift off the Rear Transfer Cover.
10. Remove the C-clip from the idler gear; remove the idler gear.
11. Remove the C-clip from the combination pulley/gear; remove the combination pulley/gear.
12. Remove the two screws from the rear side of the Transfer module that hold the Lamination
assembly.
13. Cut the wire ties on the front side of the Transfer module.
14. Remove the two screws from the front of the Transfer module that hold the Lamination
assembly.
15. Disconnect all wires that run to the Lamination assembly.
16. Remove the Lamination assembly.
17. Remove the screws (F000172) that hold the Transfer Lift Motor.
18. Disconnect the cable connector.