FARGO electronic HDP700 - Manual (Page 76)

FARGO Electronics Inc.
4-18 HDP700 Series Card Printer
NOTE
The plastic Head Location Guide (840246) and Spring (F000007) are positioned on the shaft; take care to keep
track of them for installation of the new Platen Roller.
Examine the new Platen Roller to ensure that it is free from surface defects before installing it. Be sure to
install the wide metal neck of the shaft at the front end of the Platen Roller. Once the new Platen Roller
Assembly is installed, evacuate the mid- Section of the printer with canned air to remove dust and debris.
4.5.9 Transfer Ribbon Peel Off Bar Assembly
(D840698)
Refer To Drawing 840159
Tools Needed
Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Rotate the Transfer Station outward.
6. Remove the two screws (F000191).
7. Take the Peel Off Bar out of the printer.
NOTE
From the front of the HDP Card Printer, the Peel-Off Bar on the input side should be flush with the frame; the
Ribbon Peel Bar on the output side should have a 3/16-in. (4.5mm) gap between the frame and the Ribbon
Peel Bar.
4.5.10 Ribbon Drive Hub — 2
(840324)
Refer To Drawing 840152
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver, Standard Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Bring the Transfer Station up and forward.
6. Remove the four screws (F000034) from the Front Cover.
7. Lift off the Front Cover.
8. Remove the two screws (F000034) from the Rear Transfer Cover.