FARGO electronic HDP700 - Manual (Page 63)

FARGO Electronics Inc.
HDP700 Series Card Printer 4-5
4.1.6 Card Output Hopper Cover
Refer To Drawing 840155
Tools Needed
Phillips-head Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Remove the six screws from the bottom edge of the Card Input Hopper Cover and the three
screws from the inside edge of the cover (on the right side) of the printer.
3. Lift the Card Output Hopper Cover off of the printer.
4.1.7 Back Cover
Refer To Drawing 840161
Tools Needed
Phillips-head Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Remove the five screws from the Back Cover of the printer.
3. Tilt the Back Cover outwards from the printer.