FARGO electronic HDP700 - Manual (Page 72)

FARGO Electronics Inc.
4-14 HDP700 Series Card Printer
4.5 Replacing the Transfer Station Components
4.5.1
Film Drive O-Rings
(140212)
Refer To Drawing 840152
Tools Needed
Phillips-head Screwdriver, 1.5 mm Allen Wrench, Small Standard Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Rotate the Transfer Station outward.
6. Remove the two screws (F000169) from the Rear Transfer Cover.
7. Lift off the Rear Transfer Cover.
8. Loosen the setscrew on the blue hand wheel and lift the wheel off.
9. Take the washer (130997) from the Encoder Wheel (810492).
10. Guide the Encoder Wheel (810492) gently off of the shaft.
11. Use the small standard screwdriver to remove the retaining ring (140061) from the gear
(760288).
12. Slide the gear (760288) from the shaft.
13. Remove the O-ring.
4.5.2 Encoder Wheel — 2
(810492)
Refer To Drawing 840152
Tools Needed
Torx T-10 Screwdriver, Small Standard Screwdriver, 1.5mm Allen Wrench
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Rotate the Transfer Station outward.
6. Remove the two screws (F000169) from the Rear Transfer Cover and lift off the Rear
Transfer Cover.
7. Loosen the set screw on the blue hand wheel and lift the wheel off.
8. Remove the Washer (130997) from the Encoder Wheel.