FARGO electronic HDP700 - Manual (Page 70)

FARGO Electronics Inc.
4-12 HDP700 Series Card Printer
4.4.6 Ribbon Take-Up Motor Assembly
(D840980)
Refer To Drawing 840153
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Remove the four screws (F000034) from the Print Station Cover of the printer.
6. Lower the Print Station back into position.
7. Lift the Print Station Cover off of the printer.
8. Stand at the back of the printer and remove the two screws (F000172) that secure the Ribbon
Take-Up Motor Assembly.
9. Disconnect the cable connector.
4.4.7 Headlift Motor Assembly
(840131)
Refer To Drawing 840153
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Remove the four screws (F000034) from the Print Station Cover of the printer.
6. Lower the Print Station back into position.
7. Lift the Print Station Cover off of the printer.
8. Stand at the back of the printer and Remove the two screws (F000169) that secure the
Headlift Motor Assembly.
9. Disconnect the cable connector.
10. Feed the cable out through the access hole.