FARGO electronic HDP700 - Manual (Page 82)

FARGO Electronics Inc.
4-24 HDP700 Series Card Printer
5. Bring the Transfer Station up and forward.
6. Remove the four screws (F000034) from the Front Transfer Station Cover.
7. Lift off the Front Transfer Station Cover.
8. Remove the two screws (F000034) from the bottom of the Base Module Cover.
9. Open the Front Access Door of the Card Input Hopper and the Card Output Hopper Door.
10. Remove the two screws (F000172) from each side of the Base Module Cover.
11. Rotate the Transfer Station to a 45° angle.
12. Pull the Base Module Cover carefully up and out of the printer.
13. Loosen the two Allen-head screws on the middle Pulley (F000006).
14. Take the Pulley (F000006) from the shaft.
15. Remove the Belt from the printer.
NOTE
Ensure that the new Belt is pulled taut and securely in place; if the Belt is not tight, the printer will not
function properly.
4.6.3 Stepper Motor Assembly
(840164)
Refer To Drawing 840151
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Remove the screws from the Back Cover of the printer.
3. Tilt the Back Cover outwards from the printer.
4. Remove the four screws that secure the Rear Bracket (D850208) to the printer.
5. Detach the cables running to the board.
6. Remove the screw from the Gas Spring (840366) and take off the Washers (130283 and
140040).
7. Set the Back Cover carefully aside.
8. Remove the screw from the linkage.
9. Loosen the two screws from the belt tensioner, extend the spring and then tighten the screws
on the tensioner to relax the tension on the belts.
10. Remove the belt from the stepper motor pinion.
11. Remove the three screws from the stepper motor bracket.
12. Disconnect the cable connector.
13. Remove the Stepper Motor Assembly from the printer.