FARGO electronic HDP700 - Manual (Page 74)

FARGO Electronics Inc.
4-16 HDP700 Series Card Printer
4.5.5 Lamination Take-Up Encoder Sensor Assembly
(840136)
Refer To Drawing 840152
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Rotate the Transfer Station outward.
6. Remove the two screws (F000169) from the Rear Transfer Cover.
7. Lift off the Rear Transfer Cover.
8. Remove the two screws (F000191) from the Lamination Take-Up Encoder Sensor Assembly.
9. Disconnect the cable connector.
10. Remove the Lamination Take-Up Encoder Sensor Assembly from the printer.
4.5.6 Lower Film Sensor Assembly
(840199)
Refer To Drawing 840152
Tools Needed
Phillips-head Screwdriver, Small Standard Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Bring the Transfer Station up and forward.
6. Remove the four screws (F000169) from the Front Cover.
7. Lift off the Front Cover.
8. Remove the two screws (F000034) from the Rear Transfer Cover.
9. Lift off the Rear Transfer Cover.
10. Use the small standard screwdriver to remove the Retaining Ring (140061) from the
Transfer Ribbon Roller (840318) to allow for clearance.
11. Remove the screws (F000170) from each end of the Ribbon Sensor Array.
12. Remove the screws (F000170) from the top sides of the four 1 x 1 Cross Members (840239).
13. Take the Ribbon Sensor Array Assembly from the printer.
14. Disconnect the cable connector from the board.
15. Remove the two screws from the Ribbon Sensor Board.