FARGO electronic HDP700 - Manual (Page 98)

FARGO Electronics Inc.
4-40 HDP700 Series Card Printer
4.8.5 Card Feed Gear — 3
(810271)
Card Feed Gear on the Flipper Table / Encoder Feed Motor (840100)
Refer To Drawing 840156
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver, 1.5mm Allen Wrench
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board
Assembly (140403).
4. Remove the five screws from the base of the Card Input Hopper Cover and remove the other
four screws of the printer.
5. Lift the Card Input Hopper Cover off of the printer.
6. Remove the cover from the Encoder Feed Motor.
7. Loosen the three screws (130315) from the belt tensioner.
8. Remove the pulley in front of the Card Feed Shaft Gear.
9. Slide the Card Feed Gear from the shaft.
Card Feed Gear on the Card Feed Motor Assembly (840198)
Refer To Drawing 84015
Tools Needed
Small Standard Screwdriver, Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board
Assembly (140403).
4. Remove the five screws from the base of the Card Input Hopper Cover and remove the other
four screws from inside the print station.
5. Lift the Card Input Hopper Cover off of the printer.
6. Use the small standard screwdriver to remove the Retaining Ring (140062) from the Card
Feed Shaft Gear.
7. Remove the three screws (130315) from the Card Feed Motor Assembly.
8. Lift the Card Feed Motor Assembly from the printer.
9. Slide the Card Feed Gear from the shaft.