FARGO electronic HDP700 - Manual (Page 88)

FARGO Electronics Inc.
4-30 HDP700 Series Card Printer
21. Remove the screw from the Gas Spring (840366) and take off the Washers (130283 and
140040).
22. Set the Back Cover carefully aside.
23. Open the Front Access Door.
24. Push the Release Lever down to unlock it.
25. Lift the Print Station up and back.
26. Remove the four screws (F000034) from the Print Station Cover of the printer.
27. Lower the Print Station back into position.
28. Lift the Print Station Cover off of the printer.
29. Lift the Print Station up and back.
30. Bring the Transfer Station up and forward.
31. Remove the four screws (F000034) from the Front Transfer Station Cover.
32. Lift off the Front Transfer Station Cover.
33. Remove the two screws (F000034) from the bottom of the Base Module Cover.
34. Remove the six screws from the bottom edge of the Card Input Hopper Cover and the three
screws from the inside edge of the cover (on the right side) of the printer.
35. Detach the LCD Interface Cable (D840517) from the HD7XX User Interface Board Assembly
(140403).
36. Lift the Card Input Hopper Cover off of the printer.
37. Remove the four screws from the bottom edge of the Card Output Hopper Cover and the
three screws from the inside edge of the cover (on the left side) of the printer.
38. Lift the Card Output Hopper Cover off of the printer.
39. Remove the screws (F000034) from each side of the Base Module Cover.
40. Rotate the Transfer Station to a 45° angle.
41. Pull the Base Module Cover carefully up and out of the printer.
42. Remove the Print Module by removing the screws on either side of the Cross Member.
43. Spread the side plates and lift out the Print Module
44. Remove the screws from the base plate that hold the Base Module in place.
45. Lift the Base and Transfer Modules from the Printer.
46. Remove the screw from the Gas Spring (840366) and take off the Washers (130283 and
140040) on the base module.
47. Remove the c-clips from the hinge pins; take out the hinge pins.
48. Disconnect the wires that run to the Transfer Module.