FARGO electronic HDP700 - Manual (Page 89)

FARGO Electronics Inc.
HDP700 Series Card Printer 4-31
4.7 Replacing the Gear Driven Base Module Components
Follow the procedures in this Section to replace the Gear Driven Base Module components.
4.7.1 Drive Belt – Platen Roller to Card Feed Roller
(220071)
Refer To Drawing 840151
Tools Needed
Torx T-10 Screwdriver, Phillips-head Screwdriver, Standard Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Bring the Transfer Station up and forward.
6. Remove the four screws (F000034) from the Front Transfer Station Cover.
7. Lift off the Front Transfer Station Cover.
8. Remove the two screws (F000034) from the bottom of the Base Module Cover.
9. Open the Front Access Door of the Card Input Hopper and the Card Output Hopper Door.
10. Remove the two screws (F000034) from each side of the Base Module Cover.
11. Rotate the Transfer Station to a 45° angle.
12. Pull the Base Module Cover carefully up and out of the printer.
13. Use the standard screwdriver to remove the push-on clips from all of the pulleys.
14. Remove the pulleys and belt that connects the card feed rollers.
15. Remove the pulleys and belt from the printer.
NOTE
Ensure that the new Belt is pulled taut and securely in place; if the Belt is not tight, the printer will not
function properly.
4.7.2 Drive Belt – Card Feed Roller to Card Feed Roller
(220082)
Refer To Drawing 840151
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver, Standard Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.