FARGO electronic HDP700 User Manual
Page 27
FARGO Electronics Inc.
HDP700 Series Card Printer
2-13
2.8 Output Errors
2.8.1 Cards feed into the Output Stacker, but are not lifted up into place.
•
Check operation by resetting the printer and visually confirming that the stacker cycles on power-
up.
•
Verify that the wires (840121) from the Output Stacker are connected properly and are well seated
in the wire harness.
•
Ensure that the Output Stacker is set to the correct card size. Slide the wall of the Output Stacker
to the correct card size.
•
Test the operation of the Stacker Lift Motor by disconnecting the cable connector, and connecting a
9V battery to the wires. If the motor does not turn, replace the motor. If the motor does turn, the
Lam Board may need to be replaced as described in Section 4.9.4