FARGO electronic HDP700 - Manual (Page 83)

FARGO Electronics Inc.
HDP700 Series Card Printer 4-25
4.6.4 Compound Grooved Pulley
(840328)
Refer To Drawing 840151
Tools Needed
Standard Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Remove the screws from the Back Cover of the printer.
3. Tilt the Back Cover outwards from the printer.
4. Remove the four screws that secure the Rear Bracket (D840585) to the printer.
5. Detach the cables running to the board.
6. Remove the screw from the Gas Spring (840366) and take off the Washers (130283 and
140040).
7. Set the Back Cover carefully aside.
8. Loosen the screws to the idler pulley.
9. Relieve tension from the belts and remove them.
10. Use the standard screwdriver to remove the Retaining Ring (140062) from the Compound
Grooved Pulley.
11. Take the Pulley from the shaft.
4.6.5 Pinch Roller Spring Plate-Front -- 2
(840354)
Refer To Drawing 840151
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Bring the Transfer Station up and forward.
6. Remove the four screws (F000034) from the Front Transfer Station Cover.
7. Lift off the Front Transfer Station Cover.
8. Remove the two screws (F000034) from the bottom of the Base Module Cover.
9. Open the Front Access Door of the Card Input Hopper and the Card Output Hopper Door.
10. Remove the two screws (F000034) from each side of the Base Module Cover.
11. Rotate the Transfer Station to a 45° angle.
12. Pull the Base Module Cover carefully up and out of the printer.
13. Remove the screw from the Spring Plate.