FARGO electronic HDP700 - Manual (Page 99)

FARGO Electronics Inc.
HDP700 Series Card Printer 4-41
Replacing the Card Feed Shaft Gear on the Cleaning Roller Assembly (840102)
Refer To Drawing 840156
Tools Needed
Phillips-head Screwdriver, Snap-Ring Tool, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board
Assembly (140403).
4. Remove the five screws from the base of the Card Input Hopper Cover and remove the other
four screws (on the right side) of the printer.
5. Lift the Card Input Hopper Cover off of the printer.
6. Remove the C-Ring.
7. Slide the Card Feed Shaft Gear from the shaft.
4.8.6 Encoding Feed Motor Assembly
(840100)
Refer To Drawing 840156
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board
Assembly (140403).
4. Remove the five screws from the base of the Card Input Hopper Cover and remove the other
four screws from inside the print station.
5. Lift the Card Input Hopper Cover off of the printer.
6. Push the Release Lever down.
7. Remove the cover from the Encoding feed motor.
8. Remove the two screws (130315) from the Encoding Feed Motor.
9. Remove the O-ring from the Feed Motor.
10. Lift the Encoding feed motor from the printer.