FARGO electronic HDP700 - Manual (Page 62)

FARGO Electronics Inc.
4-4 HDP700 Series Card Printer
6. Remove the screws (F000169) from the Rear Transfer Cover.
7. Lift off the Rear Transfer Cover.
4.1.4 Base Module Cover
Refer To Drawing 840155
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Push the Release Lever down to unlock it.
4. Lift the Print Station up and back.
5. Bring the Transfer Station up and forward.
6. Remove the four screws (F000034) from the Front Transfer Station Cover.
7. Lift off the Front Transfer Station Cover.
8. Remove the two screws (F000034) from the bottom of the Base Module Cover.
9. Open the Front Access Door of the Card Input Hopper and the Card Output Hopper Door.
NOTE
If the printer is equipped with an Output Stacker, the entire Card Output Hopper Cover will need to be
removed as described in Section 4.1.6.
10. Remove the screws (F000169) from each side of the Base Module Cover.
11. Rotate the Transfer Station to a 45° angle.
12. Pull the Base Module Cover carefully up and out of the printer.
4.1.5 Card Input Hopper Cover
Refer To Drawing 840155
Tools Needed
Phillips-head Screwdriver, Torx T-10 Screwdriver
1. Turn off the printer and unplug the power cord from the printer.
2. Open the Front Access Door.
3. Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board
Assembly (140403). See Drawing 840168.
4. Remove the six screws from the bottom edge of the Card Input Hopper Cover and the three
screws from the inside edge of the cover (on the right side) of the printer.
5. Lift the Card Input Hopper Cover off of the printer.