Fostex D1624 - Manual (Page 10)

D824/D1624 Reference Manual (Names and Functions)
10
1. Controller Connection Cable
Connect this cable to the recorder controller
connection jack.
2. Record Track Select key [RECORD TRACK]
Select “SAFE-READY” of the track to record. Pressing
the key once will cause the corresponding track to
enter the READY mode, and the track displayed ( )
will flash. Pressing the key again will cause the
corresponding track to enter the SAFE mode, and
the track display to turn OFF. When you only press
the RECORD button in the READY mode, the track
that is READY will enter the input monitor state, and
the recording level can be adjusted. Pressing the
RECORD button again will put the system back in
the REPRODUCTION MONITOR state. You can also
use this key to select tracks to copy & paste, move &
paste, erase and other editing features, as well as to
execute the envelope feature.
* Refer to page “ 27 ” for details about the reproduction
monitor and the input monitor.
3. Track shift key [TRACK SHIFT]
Auto Return/ Auto PLay mode is OFF.
(No indication)
AUTO RTN
AUTO PLAY
AUTO RTN
AUTO PLAY
<Note>
The keys for tracks 1-8 will function on the D824 and,
for tracks 1-16 on the D1624. However, if the D1624
is formatted in 96kHz/24bit, tracks 1-8 will function
the same as the D824.
Auto Play mode:
In this mode, playback will start automatically after the
START point is located. This function is effective at any
locate points other than the REC END point.
Auto Return mode:
When the END point is reached during playback, the START
point is automatically located in this mode. This function
is effective only when the START and END points have
been specified.
Detachable Controller section
1 2 3 4 5 6 7 8 9 10
11
12
13
14 15 16
17
18
19
21 23 25 27 29 31
20 22 24 26 28 30
32 33 34
35
36
<Note>
The Auto Return function is works only during playback.
In the recording mode, the START point will not be
located automatically when the END point is reached.
Auto Repeat mode:
This mode is a combination of Auto Play and Auto Return,
and plays back the part between the START and END points
repeatedly. The auto repeat function is effective only when
the START and END points have been specified correctly.
* Refer to page “ 57 ” for details.
4. Auto Play/Auto Return key [AUTO RTN/PLAY]
Pressing this key repeatedly will change Auto Play
mode, Auto Return mode, and Repeat mode On/Off
as follows: ( : LED off, : LED light up)
Auto PLay mode is ON.
(Only the AUTO PLAY LED is lit. )
Auto Return mode is ON.
(Only the AUTO RTN LED is lit. )
Auto Repeat mode is ON.
(Both AUTO PLAY and AUT RTN LEDs are lit. )
* Refer to page “ 27 ” for details about the reproduction
monitor and the input monitor.
<Function only for D1624>
When the TRACK SHIFT LED is lit by pressing this key,
SAFE-READY can be executed for record tracks 9-16
(Except when formatted in 96kHz/24bit). This does not
function on the D824.
<Common function for D824/D1624>
The input monitor for all tracks can be switched ON/
OFF with each press of this key while pressing on the
SHIFT key. When all tracks are set to input monitor,
ALL INPUT LED will light.