Fostex D1624 - Manual (Page 69)

D824/D1624 Reference Manual (Editing Tracks)
69
Copy & Paste between programs
Copy & Paste between programs can be performed
using the procedures below in the same manner as
in the previous “Copy & Paste in the same program.”
1.
2.
3.
4.
5.
6.
7.
8.
Store the copy (or move) start point (CLIPBOARD
IN point), end point (CLIPBOARD OUT point), and
the paste start point (AUTO PUNCH IN point).
Check the stored edit points using the Preview
function and make adjustments if necessary.
Specify the track to be copied and copy it in the
clipboard (Copy Clip).
Switch to program for pasting using the program
select function.
Register the copy starting point (AUTO PUNCH
IN point) in the switched program.
Check the registered editing point with the
“Preview function” and if necessary, correct the
editing point.
In the same way as before, enter the editing mode
by pressing the EDIT key. [Copy Paste?] will be
displayed after pressing the EDIT key.
Next, specify the track and amount to be pasted
and execute paste.
Checking the clipboard data
Data copied to the clipboard can be confirmed even
after switching the program by the above procedure.
For example, when a specific data in Program 1 is
copied to the clipboard and then switched to
Program 2 in which it is to be pasted, as mentioned
before, if the PLAY button is pressed while pressing
on the STOP button, you can listen to data copied in
Program 1 (clipboard play).
During clipboard play, [P01] will appear in the
display to indicate that copy data in Program 1 is
being played back.