Fostex D1624 - Manual (Page 54)

D824/D1624 Reference Manual (Storing a Locate Point (Edit Point)
54
1
2 3
4
Flashing
44.1kHz
42 ∞
_
OL
0
8 7 6 5 4 3 2 1
30
24
18
12
9
6
3
16 15 14 13 12 11 10 9
Storing and editing the locate points to the memory keys
• Select the desired Time Base using the DISP SEL key and EXECUTE/YES key an if you wish to use a Time
Base other ABS.
• The stored or edited locate points are used only in the currently-selected Program.
Storing in real-time
You can store the locate point (in the ABS, MTC, or BAR/BEAT/CLK Time Base) in real-time while the
recorder is playing.
1.Press the PLAY button to play back data.
2.When the point you wish to store is reached, press
the STORE key.
The time value or bar/beat/clock value of the point is
captured. The recorder enters data edit mode.
<Note>
The following menu (##=number from 00-99) appears
when pressing the STORE key. This menu is used to store
data in the LOCATE ley, described later. Ignore this
menu and go to the next step when storing data in the
memory key.
3.Press the desired memory key.
The STORE LED turns off.
The captured time value (or bar/beat/clock value) is
stored in the memory key. After the data is stored, the
recorder displays the previous Time Base and continues
playback.
4.Press the STOP button.
<Please remember this!>
• If you set “BAR/BEAT Resolution mode” in SETUP
mode to ON, the recorder will round off the CLK value
of the captured bar/beat/clock value. That is, the
locate point will be at the beginning of the beat (00).
Refer to page “
115 ” for more information.
• When pressing the STORE key in step 2, if the STORE
key is pressed while holding down the SHIFT key,
data to be registered will be held and be confirmed.
To register data after confirmation, press the STORE
key again and press the desired memory key.
3 1, 4
2
Editing and storing data
You can recall data stored in the memory key, edit it, and store it again.