Duplicating a program, Important, Press the exit/no key, or stop button – Fostex D1624 User Manual
Page 35: Press the execute/yes key again, Press the exit/no key (or stop button)
35
D824/D1624 Reference Manual (Handling Programs)
44.1kHz
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
44.1kHz
SURE?
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
Duplicating a Program
<Notes>
* Duplicating a program is possible only when the Multiple Undo function is set to ON when formatting the
current drive. In a current drive with this setting at OFF, the [PGM Duplicate?] message will not display when
pressing the EDIT key mentioned below.
* The program which can be duplicated must be the currently active program.
Therefore, the program you wish to duplicate must be activated prior to executing the duplicating mode.
To enter a title:
• Turn the JOG dial, or pressing the NEXT
key and PREV key for the flashing cursor
to voluntarily input alphanumerics.
• Move the flashing cursor with the SHUTTLE
dial. The title can contain up to 16
alphanumeric characters.
• You can input the following alphanumerics
and symbols.
6. When you finish entering the title, press the
EXECUTE/YES key.
Program 2 (PGM 02) and its title are set.
The display shows the ABS Time Base indication of the
Program.
<Important!>
• When you create a new Program by selecting the [New
PGM ?] menu, a new Program is created with an
increment number.
That is, if only one Program exists and when you
create a new Program, it will be named Program 2.
If Programs 1-5 already exist, a new Program number
will be 6.
• If there is insufficient recording space on the disk,
you cannot create the new Program. Each time you
create a new Program, the recordable area on the
disk will decrease.
7. Press the EXIT/NO key, or STOP button.
Any program content (Recording data/various setup items) can be duplicated but with a separate
program number.
1. With this recorder in the stop mode, press
the EDIT key to display [PGM Duplicate?] (?
flashes).
2. Press the EXECUTE/YES key.
As an example, the following is displayed and [SURE?]
will flash. This means that program 01 will be duplicated
for program 05, the new program 05. Refer see <Note>
below.
<Note>
The program to be duplicated will be assigned with a
program number following that of the program
presently existing in the disk.
If [Duplicate P01 > 05] is displayed as in the previous
example, this indicates that four programs presently
exist in the disk and that the new program will be
number 05.
If the duplicated program is to be checked or you wish
to switch to this program, refer to the next item
“Selecting a program.”
3. Press the EXECUTE/YES key again.
The display will change to head of the duplicated
original program (P01 in this example), and
[COMPLETED!] will light.
4. Press the EXIT/NO key (or STOP button).
[COMPLETED!] will be extinguished.
By following these procedures, the same content in
program 01 is duplicated in program 05.
Flashing
Flashing