Fostex D1624 - Manual (Page 59)

D824/D1624 Reference Manual (Locate Function)
59
AUTO RTN END point AUTO RTN START point
LOCATE
PLAYBACK
START
PLAYBACK
AUTO RTN END point AUTO RTN START point
PLAYBACK
START
AUTO PUNCH IN point AUTO PUNCH OUT point
Rehearsal range
PLAYBACK
LOCATE
<Hint>
You can make repeated Auto Punch In/Out rehearsal much easier and quicker by using the
Auto Repeat function.
Set the AUTO RTN START point prior to the AUTO PUNCH IN point, and set the AUTO RTN
END point after the AUTO PUNCH OUT point. The recorder will repeat the operation
automatically so you can concentrate on your rehearsal.
Cancel Auto Repeat mode before you record a take.
The recorder will play this range repeatedly for rehearsal, which makes it easy for you to
check the recording level and practice your performance.
Auto Repeat function
The Auto Repeat function allows the recorder to repeat playback up to the AUTO RTN END point, automatically
locate the AUTO RTN START point, then play up to the AUTO RTN END point until you cancel the function by
pressing the STOP button. To enable this function, both AUTO PLAY mode and AUTO RTN mode should be
turned on, and the AUTO RTN START point and the AUTO RTN END point should already be set.
Using this function will facilitate the Auto Punch In/Out and Manual Punch In/Out rehearsal. See “Hint” after
the following section.
<Operation of the Auto Repeat mode.>
1. Store the AUTO RTN START and AUTO RTN END
points.
Refer to the chapter “Storing a Locate Point (Edit Point)”
on page “
54 ” for information on storing the desired
points in the AUTO RTN START key and the AUTO RTN
END key.
2. Press the AUTO RTN/AUTO PLAY key to turn on
the [PLAY RTN], [AUTO PLAY] LEDs.
3. Start playback a little before the AUTO RTN START
point.
The recorder operates as shown in the diagram, and stops
at the AUTO RTN START point.
• You can set a preroll time in the [Preroll Time?] menu
in SETUP mode so that the recorder will start playback
preroll time before the locate point. You can set the
preroll time from 0 to 10 seconds. Refer to the chapter
“Changing the Initial Settings (SETUP Mode)” on page
“
108 .”