Setting the midi device number, Setting bar/beat resolution mode, Setting the midi device id – Fostex D1624 User Manual
Page 116: Use the jog dial to turn the mode [on] or [off, Press the execute/yes key, Flashing
116
D824/D1624 Reference Manual (Changing the Initial Setting <SETUP mode>)
44.1kHz
SETUP
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
44.1kHz
SETUP
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
44.1kHz
SETUP
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
44.1kHz
SETUP
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
Flashing
Setting BAR/BEAT resolution mode
1.While the recorder is stopped, press the SETUP
key to enter SETUP mode.
2.Turn the JOG dial to select [Resolution ?] ([?]
flashes), then press the EXECUTE/YES key.
The current BAR/BEAT resolution mode setting appears
on the display.
Pressing the EXECUTE/YES key turns off the flashing [?]
character, and the BAR/BEAT resolution mode setting
flashes. With the initial setting, [Off] flashes as shown
below.
3.Use the JOG dial to turn the mode [On] or [Off].
When you turn the JOG dial clockwise and counter-
clockwise, [On] and [Off] flash alternately.
Selecting [On] turns BAR/BEAT resolution mode on, and
selecting [Off] turns BAR/BEAT resolution mode off.
4.Press the EXECUTE/YES key.
The selected mode setting is stored, and [?] flashes.
To cancel the operation, or to restore the setting
obtained prior to the EXECUTE/YES key press, press the
STOP button or the EXIT/NO key. Each time you press
one of these keys, the recorder returns to the previous
hierarchy level of the menu, and finally exits SETUP
mode and displays the previous Time Base.
Setting the MIDI device number (“Device ID ?” menu)
The “Setting the MIDI device number” menu enables you to set the recorder device ID number required to
control the unit from a sequence software using MMC (MIDI Machine Control) or FEX (Fostex System Exclusive
Message).
The transmit device ID links to this setting. You can set the device ID from 00 to 99.
However, if the device ID number of the message the recorder receives is [7F], the recorder will recognizes it
to perform the corresponding operation, regardless of its device ID setting.
• Initial setting:
[00]
• Device ID:
[00] ~ [99]
* This setting is shared by all Programs in the same disk.
* The settings cannot be saved and loaded as part of the song data.
* The settings are maintained after you turn off the power to the recorder.
Setting the MIDI device ID
1.While the recorder is stopped, press the SETUP
key to enter SETUP mode.
2.Turn the JOG dial to select [Device ID?] ([?]
flashes), then press the EXECUTE/YES key.
The current MIDI device ID number appears on the
display. Pressing the EXECUTE/YES key turns off the
flashing [?] character, and the MIDI device ID number
flashes. With the initial setting, [00] flashes as shown
below.
Flashing