Edit and re-store data that is already stored, Next press the locate key, Press the store key (the store led lights up) – Fostex D1624 User Manual
Page 56: The menu to select the locate number will appear, Flashing
D824/D1624 Reference Manual (Storing a Locate Point (Edit Point)
56
3.Select the LOCATE number desired using the JOG
dial.
LOCATE number from 00-99 are selectable. However,
select a number other then 00.
4.Next press the LOCATE key.
The time base (or bar/beat/clock) put on hold is stored
as data in the LOCATE number selected. The system
will return to the original time base when the storage
process is completed, and playback is resumed.
5.After completing the store process, press the
STOP button to stop the recorder section.
<Please remember this!>
• If you set “BAR/BEAT Resolution mode” in SETUP
mode to ON, the recorder will round off the CLK value
of the captured bar/beat/clock value. That is, the
locate point will be at the beginning of the beat (00).
Refer to page “
115
” for more information.
• When pressing the STORE key in step 2, if the STORE
key is pressed while holding down the SHIFT key,
data to be registered will be held and be confirmed.
To register data after confirmation, press the STORE
key again and press the desired memory key.
Edit and re-store data that is already stored
3
1
2, 6
2
3, 5
4
RECALL the desired time data already stored in the LOCATE key, edit that data and re-store it.
1.Press the RECALL key while the recorder is
stopped.
The menu to select the LOCATE number will appear.
2.Turn the JOG dial to select the desired LOCATE
number, then press the LOCATE key.
The data edit mode will appear when the data stored in
the selected LOCATE number appears.
3.Turn the SHUTTLE dial to move the (cursor)
column of the time indication to edit (cursor
flashing point), increase or decrease the number
setting with the JOG dial or input the desired time
base.
Flashing
Flashing
44.1kHz
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
44.1kHz
SETUP
LOCATE
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
4.Press the STORE key (the STORE LED lights up).
The LOCATE number selection menu to store data will
appear.
5. You can use the JOG dial to input the desired
LOCATE number.
6. Press the LOCATE key.
The edit time data is stored as the time data for the
selected LOCATE number.
Flashing
44.1kHz
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
• If the STORE key is press instead of the LOCATE key
at this stage, it becomes possible to directly LOCATE
the time data of the selected LOCATE number. For
more details refer to the next section on “Location
Functions.”