Fostex D1624 - Manual (Page 102)

102
D824/D1624 Reference Manual (Changing the Initial Settings <SETUP mode>)
42 ∞
_
OL
0
8 7 6 5 4 3 2 1
30
24
18
12
9
6
3
16 15 14 13 12 11 10 9
NOs Of Event ?
Drive Sel. ?
Load PGM?
Save PGM ?
Disk Format?
Disk Optimize ?
Signature Set?
Tempo Map Set ?
Title Edit ?
Delete PGM ?
Click ?
Preroll Time?
Midi Sync Out?
Frame Rate ?
MTC offset ?
Offset Mode?
Ref. TC ?
Rec Protect ?
D. in ?
D. out?
Slave Type ?
Sync Preset?
Clock Sel. ?
Device ID ?
Resolution?
Reserved
Drive Info ?
Date & Time Set ?
Reserved
Reserved
Offset Disp ?
Virtual LTC ?
Selecting SETUP mode
Follow the steps below to select the desired SETUP menu in SETUP mode.
1. While the recorder is stopped, press the SETUP
key on the control panel.
Pressing the SETUP key causes the recorder to enter
SETUP mode. The recorder displays the first hierarchy
level of the SETUP menu you selected before you turned
off the power. At this time, the menu graphic appear as
shown below. The flashing menu indicator is the
currently-selected menu. Turning the JOG dial will select
a different menu and the corresponding menu indicator
will flash.
<Note>
With the factory initial settings, or when you turn on
the power again after you format a current drive disk,
“Signature Set? (Setting a signature)” appears. Otherwise,
the first hierarchy level of the previously-selected SETUP
menu appears.
To exit SETUP mode, press the STOP button or the EXIT/
NO key. Each time you press one of these keys, the
recorder returns to the previous hierarchy level of the
menu, and finally exits SETUP mode.
The title of the SETUP menu
appears. You can select a
different menu via the JOG
dial.
This lights up when the
recorder enters SETUP
mode.
This indicates the position of the SETUP menu.
Selecting a menu via the JOG dial will move the
flashing cursor.
2. Select the desired menu using the JOG dial, then
press the EXECUTE/YES key.
The recorder displays the second hierarchy level of the
selected SETUP menu, where you can set parameters.
<Note>
Although titles of the “Ref. TC ?” menu, “Offset Disp ?” menu, “Virtual LTC ?”menu and “Sync Preset ?” menu will
also be displayed, these menus will only function when an optional Model 8345 TC/SYNC card is installed.
Refer to the APPENDIX for details. “Reserve” is the extra position for future extension of the SETUP mode menu.