Fostex D1624 - Manual (Page 88)

D824/D1624 Reference Manual (Saving and Loading Song Data)
88
OPTICAL
D1624 D824
adat DAT
DIGITAL/DATA IN 1-8
DIGITAL/DATA IN 1-8
DIGITAL OUT
Loading the data using DIGITAL/DATA IN
Load the data by S/P DIF digital signals (or adat digital signals) from the DIGITAL/DATA IN jack of
the recorder.
* Restore the initial settings on the recorder.
* Set the same sampling rate on the external digital device and the recorder.
Connecting the external device
Connect DIGITAL/DATA IN connectors of the recorder to the digital output connectors on the external
digital device.
<Notes>
* The recorder has DIGITAL/DATA IN connectors for an S/P DIF digital signal (OPTICAL) and for an adat digital
signal. These connectors have the same shape but carry different information.
When using the D1624, use the DIGITAL/DATA IN 1-8 connector. Do not use the DIGITAL/DATA IN conector.
* Do not remove the optical cable or perform any other operation that would disconnect the S/P DIF signal until
the session is complete. Otherwise, the recorder will generate noise, and affect the connected device.
* If the external device has only COAXIAL type (RCA) digital I/O connectors, connect an optional COP-1/96k
(optical/coaxial converter) to use an S/P DIF digital signal.
* Connecting both output and input connectors on the recorder to the input and output connectors on the
external digital device respectively may generate a digital loop. Refer to “Connecting a digital mixer” on page
“
50 ” for more information.
Setting up an external device
1.Setup the external device so that it can output a digital signal.
2.Locate the beginning of the pilot signal recorded in the saved data.
* Refer to the instruction manual that came with your external digital device for details.
Executing the load operation
You will use the “Load PGM ?” menu in Setup mode.
* Input format available : adat, DAT, SCSI (6)
* Programs available : P01 - P99
* Track available : When using an adat or DAT: Tracks 1-8, Tracks 1-16, Tracks 1-24,
Tracks 9-16, Tracks 9-24, Tracks 17-24;
When using a SCSI disk: All tracks will be automatically selected.