Fostex D1624 - Manual (Page 80)

D824/D1624 Reference Manual (MIDI Sync Function)
80
3. With the SETUP mode “MTC offset mode setting,” whether the MTC offset time will be output (ABS) at
the ABS 00h 00s 00f 00sf point or at the 001BAR 1BEAT 00CLK (bar/signature) point of the tempo map, is
selected.
Refer to page “ 111 ”, SETUP mode “MTC offset mode setting” for operating procedure and details.
4. A random offset time is set by the SETUP mode “MTC offset time setting.”
Refer to page “ 110 ”, SETUP mode “MTC offset time setting” for operating procedure and details.
5. “00” is set with the SETUP mode “MIDI device ID setting.”
Refer to page “ 116 ”, SETUP mode “MIDI device ID setting” for operating procedure and details.
6. Set to “Int.” the clock setting by the SETUP mode “Clock setting.”
Refer to page “ 117 ”, SETUP mode “Clock setting” for operating procedure and details.
7. Press the DISP SEL key while holding down the SHIFT key to change the time base display to MTC.
Setup of the recorder (#2) <Slave 1> and (#3) <Slave 2>
1. Set the SETUP mode “MTC Frame rate setting” to the same frame rate as in the recorder (#1).
Refer to page “ 109 ”, SETUP mode “MTC Frame rate setting” for operating procedure and details.
2.Set the SETUP mode “MTC offset mode setting” to the same mode as in the recorder (#1).
Refer to page “ 111 ”, SETUP mode “MTC offset mode setting” for operating procedure and details.
3. Set the SETUP mode “MTC offset time setting” to the same offset time as in the recorder (#1).
Refer to page “ 110 ”, SETUP mode “MTC offset time setting” for operating procedure and details.
4. Set the SETUP mode “MIDI device ID setting,” to “01” in the recorder (#2), and to “02” in the recorder (#3).
Refer to page “ 116 ”, SETUP mode “MIDI device ID setting” for operating procedure and details.
5. Press the EXECUTE/YES key While holding down the SHIFT key, set slave mode to “On.”
[CHASE] indicator will be flashing in the display.
* Slave type initial setting: Vari
* Permissible setup item: Vari, Free
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
Refer to page “ 112 ”, SETUP mode “Slave type setting”, for operating procedure and details.
6. Using the SETUP mode “Slave type setting,” set slave type to “Free.”
8. Press the DISP SEL key while holding down the SHIFT key, to change the time base display to MTC.
7. Set to “Word” the clock setting by the SETUP mode “Clock setting.”
Refer to page “ 117 ”, SETUP mode “Clock setting” for operating procedure and details.