Setting the operating clock, Setting the operating clock (“clock sel ?” menu), Press the execute/yes key – Fostex D1624 User Manual
Page 117: With the jog dial, select the operating clock, Flashing
117
D824/D1624 Reference Manual (Changing the Initial Settings <SETUP mode>)
44.1kHz
SETUP
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
44.1kHz
SETUP
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
Flashing
3. Use the JOG dial to set the desired MIDI device ID
number.
Turning the JOG dial clockwise increments the value, and
turning it counter-clockwise decrements the value.
4. Press the EXECUTE/YES key.
The MIDI device ID number is stored, and [?] flashes.
To cancel the operation, or to restore the setting
obtained prior to the EXECUTE/YES key press, press
the STOP button or the EXIT/NO key. Each time you
press one of these keys, the recorder returns to the
previous hierarchy level of the menu, and finally exits
SETUP mode and displays the previous Time Base.
Setting the Operating Clock (“Clock Sel ?” menu)
The “Setting the Operating Clock” menu is used to setup the operating clock of the recorder.
If digital input is set to asynchronous mode of [adat: Async] or [SPDIF: Async] in the previous [D. in?] (Digital
input setting), whether this recorder is to operated by its internal clock or synchronized to the word clock
signal from the external digital equipment should be selected when recording in digital from external digital
equipment (DAT, adat, CD, MD, etc.). The initial setting is set to synchronize to the internal clock.
The setup item [Video] is effective if an optional Model 8345 TC/SYNC card is installed.
For details, refer to the “APPENDIX.”
1.While the recorder is stopped, press the SETUP
key to enter SETUP mode.
2.Turn the JOG dial to select [Clock Sel ?] ([?]
flashes), then press the EXECUTE/YES key.
A flashing [?] will extinguish by pressing the EXECUTE/
YES key and the operating clock information that was lit
will being flashing. Initial setting, it will show “Int.”
• Initial setting:
[Int.]
• Device ID:
[Int.] (Internal clock)
[Auto]
[Word]
[Video] (Tis item will be effective if the optional Model 8345 TC/SYNC card is
installed in this recorder.)
* This setting is shared by all Programs in the same disk.
* The settings cannot be saved and loaded as part of the song data.
* The settings are maintained after you turn off the power to the recorder.
3.With the JOG dial, select the operating clock.
If [Int.] (initial setting) is selected, the recorder will
operate using the internal clock.
If [Auto] is selected, the recorder will sync to an external
digital signal.
If [Word] is selected, the recorder will sync to an external
word clock signal.
4.Press the EXECUTE/YES key.
The selected operating clock will register and [?] in step-
2 above, will flashes.
Refer to the chart of next page in regards to “Digital input
setting” and “Operating clock setting.”
To cancel the operation, or to restore the setting
obtained prior to the EXECUTE/YES key press, press
the STOP button or the EXIT/NO key. Each time you
press one of these keys, the recorder returns to the
previous hierarchy level of the menu, and finally exits
SETUP mode and displays the previous Time Base.
Setting the operating clock