Setting a preroll value, Setting a preroll value (“preroll time ?” menu), Setting a preroll time – Fostex D1624 User Manual
Page 108: Press the execute/yes key, Flashing
108
D824/D1624 Reference Manual (Changing the Initial Settings <SETUP mode>)
44.1kHz
SETUP
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
44.1kHz
SETUP
42
∞
_
OL
0
8
7
6
5
4
3
2
1
30
24
18
12
9
6
3
16
15
14
13
12
11
10
9
Locate point (stored in the memory key).
This point is actually located.
This point is located if the current position is before the locate point.
Preroll time (before the locate point) can be set between 00 and 10 seconds.
Flashing
Setting a preroll value (“Preroll Time ?” menu)
The recorder features the Preroll function that enables you to locate a position a few seconds prior to a
specified locate point. The “Setting a preroll value” menu allows you to set the preroll time (in seconds).
The Preroll function is convenient when you wish to monitor the audio data from a point slightly before the
locate point.
• Initial setting:
[00] second
• Setting range of preroll time:
[00]-[10] seconds in one second steps
* You can set the value for each Program individually.
* The settings can be saved and loaded as part of the song data.
* The settings are maintained after you turn off the power to the recorder.
This point is located if the current position is after the locate point.
Setting a preroll time
1.While the recorder is stopped, press the SETUP
key to enter SETUP mode.
2.Turn the JOG dial to select [Preroll Time ?] ([?]
flashes.), then press the EXECUTE/YES key.
The current preroll time setting appears on the display.
Pressing the EXECUTE/YES key lights up the flashing [?]
character steadily; the current setting flashes. The initial
setting is [00] as shown below.
3.Turn the JOG dial to enter a desired preroll time
value.
You can set a value in one-second increments.
Rotating the JOG dial clockwise increases the value, and
rotating it counter-clockwise decreases the value.
4.Press the EXECUTE/YES key.
The display shows the value, then returns to the
indication that appeared in step 2.
To cancel the setting operation, or to restore the setting
obtained prior to the EXECUTE/YES key press, press
the STOP button or the EXIT/NO key. Each time you
press one of these keys, the recorder returns to the
previous hierarchy level of the menu, and finally exits
SETUP mode and displays the previous Time Base.