Fostex D1624 - Manual (Page 75)

D824/D1624 Reference Manual (MIDI Sync Function)
75
Setup of the recorder
1. Because the MIDI clock and song position pointer will be output from the recorder, set the SETUP mode
“MIDI sync signal output setting” to “CLK.”
* Initial setting: MTC
* Permissible setting: CLK (MIDI clock and song position pointer:”CLK”)
MTC (MIDI time code: “MTC”)
Off (No output of MIDI sync signal)
* This item can be setup for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
Refer to page “ 109 ”, SETUP mode “MIDI sync signal output setting” for correct operating procedures.
2. The meter in the desired bar can be set by “Time signature setting” of the SETUP mode.
* Initial setting: 001 bar, 4/4 signature .
* Permissible bar setting: 001~999
* Permissible meter setting: 1/4, 2/4, 3/4, 4/4, 5/4, 1/8, 3/8, 5/8, 6/8, 7/8, 8/8,
— — (Elimination of signature)
* Permissible setting of maximum number of points: 64 points
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
Refer to page “ 103 ”, SETUP mode “Time Signature Setting” for operating procedure.
3. Tempo in the desired bar can be set by “Tempo setting” of the SETUP mode.
Tempo map is made in steps 2 and 3.
* Initial setting: 001 bar, 1st meter, Tempo120.
* Permissible bar setting: Follows the previous “Setup of the time signature.”
* Permissible signature setting: Follows the previous “Setup of the time signature.”
* Permissible setting of tempo:
Quarter note=30~250 .... (Tempo elimination)
* Permissible setting of maximum number of points: 64 points
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
Refer to page “ 105 ”, SETUP mode “Tempo Setting” for operating procedure.
4. Set the SETUP mode “Metronome setting” to ON if click sound is to be output according to the setup
tempo map.
* Initial setting: Off
* Permissible setup item: Off, On
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
Refer to page “ 107 ”, SETUP mode “Metronome setting” for operating procedure.
5. Press the DISP SEL key while holding down the SHIFT key, and then change the time base display to
BAR/BEAT/CLK.
Confirming the MIDI clock sync
During recording and at playback following the recording, the time base (BAR/BEAT/CLK) is
displayed in accordance to the setup tempo map, and the MIDI clock and song position pointer
is also output.
Confirm that the travel position (BAR/BEAT/CLK) of the recorder and the travel position of the
synchronized MIDI sequencer are matched.