Genicom 3850 - Manual (Page 101)

97
Graphic Direction
BI : All graphics modes are printed in bi-directional mode.
UNI : All graphics modes are printed in uni-directional mode. In order to obtain even
higher line-to-line column alignment, you may select uni-directional (UNI) graphics mode.
SPEC: GRAPH DIRCT ENTER
SPEC:GRAPH>BI ↓
SPEC:GRAPH:UNI ↓
Go back to the top level of the menu with the PRIOR key and press the
↓ key to select the
next menu item (FORM THICKNESS displays).
Adjusting for the Thickness of Your Forms
You can select three mutually independent methods of making the adjustment for the
thickness (also known as the print head-to-paper gap) of the forms you plan to use.
FORM THICKNESS
To change the methods, press the ENTER key to go from the top level to the second level as
shown below:
Manual Gap Adjust
This method allows you to override the automatic and fixed gap adjust routines. When
enabled (Y) you must set the gap by means of the gap adjust wheel. This wheel is located
to the left of the ribbon cartridge. The marks of the wheel (1...2...3) correspond to the
number of parts in your form set.
FORM THICKNESS ENTER
FORM: MANUAL ENTER
FORM:MANUAL>N ↓
FORM:MANUAL:Y ↓