Genicom 3850 - Manual (Page 94)

90
Selecting the Page Setup
Select page setup as shown below.
PAGE SETUP
To change the page setup, press the ENTER key to go from the top level to the second level
as shown below. There are five page setup selections:
Top Print Reference
When using pre-printed forms, it may be desirable to begin printing at a particular
position on the first form and at the same position on successive forms. To do so, adjust
the top print reference (also known as load offset).
The range is from -90/90 to +180/90 inch or from -1/+2 inches depending upon System
Menu (P
P P R R R O O O G G G R R R A A A M M M U U U N N N I I I T T T S S S ).
This value affects only the currently selected paper paths.
PAGE SETUP ENTER
PAGE: TOP REF ENTER
PAGE:TREF>0/90 ↓ ↓
o o r r
↑ ↑
Line Spacing
Select the line spacing in lines per inch (lpi).
PAGE: LINES/INCH ENTER
PAGE:LPI>6 ↓
PAGE:LPI:4 ↓
PAGE:LPI:3 ↓
PAGE:LPI:2 ↓
PAGE:LPI:12 ↓
PAGE:LPI:8 ↓