Genicom 3850 - Manual (Page 102)

98
Automatic Gap Adjust
This, the easiest method, causes the printer to automatically make the adjustment based
upon the form thickness selected. This is the recommended method. An "offset" to this
automatic adjustment may be selected in order to fine-tune the gap to your forms. The
range of the offset is from -3/+5. With or without an offset, the printer will automatically
make the adjustment each time you load a new set of forms. Please note that for forms of
varying thickness, this method may or may not make an appropriate adjustment
depending upon which area of the form was used during the adjust procedure.
The automatic gap value will be stored as a "path" parameter or as a "format" parameter
based upon the G
G G A A A P P P A A A S S S S S S I I I G G G N N N selection in the System Menu.
If GAP ASSIGN:PATH is selected in the System Menu, then the offset value will be stored
for the currently selected path and will be recalled the next time paper is loaded in the
current path.
If GAP ASSIGN:FORMAT is selected in the System Menu then the offset value will be
stored in the current format. The current format must be saved to a numbered (1-4)
format. Then, the next time that particular format number is selected, the offset gap value
will be recalled.
FORM: AUTO ENTER
FORM:AUTO>0 ↓ or ↑