Genicom 3850 - Manual (Page 96)

92
Selecting the Line Setup
Select line setup as shown below.
LINE SETUP
To change the line setup, press the ENTER key to go from the top level to the second level
as shown below. There are three line setup selections:
Left Margin
Select the left margin (up to 13.4 inches) in CPI or in inches depending upon System Menu
(P
P P R R R O O O G G G R R R A A A M M M U U U N N N I I I T T T S S S ). The maximum left margin value is RM-1.
LINE SETUP ENTER
LINE: LEFT MARGIN ↓
LINE:LM>0 ↓ ↓
o o r r ↑ ↑
Right Margin
Select the right margin (no less than 2 inches) in CPI or in inches depending upon System
Menu (P
P P R R R O O O G G G R R R A A A M M M U U U N N N I I I T T T S S S ). The minimum right margin value is LM+1.
LINE: RGHT MARGIN ENTER
LINE:RM>136 ↓ or ↑
Left Reference
Select the left print reference (up to 0.5 inch) in CPI (unit: 1/120 inch. Range 0-60) or in
inches depending upon System Menu (P
P P R R R O O O G G G R R R A A A M M M U U U N N N I I I T T T S S S ). Max. = 0.5 inch
LINE: LEFT REF ENTER
LINE:LREF>0/120 ↓ or ↑
Go back to the top level of the menu with the PRIOR key and press the
↓ key to select the
next menu item (PRINT MODES displays).