Genicom 3850 - Manual (Page 56)

52
Retract Timer
If you have pressed the TEAR key to move paper to the tear-off position, then the length of
time that the printer waits before retracting the paper is variable from one second to 98
seconds. If the value saved is "99" then paper retract will occur only if
TEAR key is pressed
or if data is received from host.
You can increase or decrease the retract timer by pressing the
↑ or the ↓ keys respectively.
The default retract time is 10 seconds.
OPT: RETRACT TIME ENTER
OPT:RET TIME> 1-99 ↓
Confirm Park
Y : Upon receipt of the path select or park command from the host, and prior to park
current path, the paper will move to the tear-off position. The LCD will display PLEASE
TEAR OFF
. You must press the TEAR or the PARK keys that enable the subsequent form
park.
N
: Paper Parking will occur without moving to tear-off position.
OPT: CONFIRM PARK ENTER
OPT:CNFRM PARK>N ↓
OPT:CNFRM PARK:Y ↓
Interlock Sensor
Y : Enables error indication of rear pull tractor cover or rear pull tractor assembly not
installed.
N
: Disables this error indication.
OPT: INTERLOCK ENTER
OPT:INTERLOCK>Y ↓
OPT:INTERLOCK:N ↓