Genicom 3850 User Manual
Page 135
Advertising
131
4. Insert the Rear Pull tractor assembly and the corresponding attachment area covers (with
the slot) as shown in figure.
5. Turn the printer on.
6. To select the Push-Pull paper path, press the
PATH
key until the
Front 1
led is turned on.
To remove the Rear Pull tractor assembly:
1. Turn the printer off.
2. Push the lever on the Rear Pull tractor
down and lift the tractor assembly out of
the printer.
3. Insert the Rear Pull tractor assembly
cover and make sure that the interlock
connector is correctly inserted.
If the cover is not inserted, the printer is blocked.
Advertising