Genicom 3850 - Manual (Page 55)

51
Automatic Wrap
If the printer receives printable data from the host, and such data exceeds the current line
length (right margin), then the printer will (Y) or will not (N) continue to print the
remaining data on the following line based upon your selection.
If you disable auto wrap by selecting N, then the data beyond the right margin is discarded
up to the next line terminator.
OPT: AUTO WRAP ENTER
OPT:AUTO WRAP>Y ↓
OPT:AUTO WRAP:N ↓
Automatic Tear Off
Y : If the printer is at the TOF
• and there is no data received after 1.5 sec., the paper will automatically advance to the
tear-off position.
• if data is received, then the printer will sound 4 beeps (approx. 0.25 sec. apart), retract
the paper to the last print position and continue to print. If you press the TEAR key
tear off retraction is executed.
N. Tear off only occurs if the TEAR key is pressed.
OPT: AUTO TEAR ENTER
OPT:AUTO TEAR>N ↓
OPT:AUTO TEAR:Y ↓