Genicom 3850 - Manual (Page 80)

76
Assigning a Format to a Paper Path
Any of the four formats may be assigned to any of the six paper paths as shown below.
PATH/FORMAT
This function assigns the Format indicated to the Paper Path. The same Format may be
assigned to all Paper Paths. The Format changes:
a) if the paper path changes.
or
b) if another Format is selected from the menu or from the host.
To change format-to-path selections, press the ENTER key as shown above to move from
the top level to the second level.
Each path below will only be displayed if it has been enabled by the P P P A A A T T T H H H O O O P P P T T T I I I O O O N N N selection.
FRONT1 Path/Format
P/F: FRONT 1 ENTER
P/F:FRNT1>CURRNT ↓
P/F:FRNT1:FORM#1 ↓
P/F:FRNT1:FORM#2 ↓
P/F:FRNT1:FORM#3 ↓
P/F:FRNT1:FORM#4 ↓
FRONT2 Path/Format (displayed if the optional Front2 Push tractor is installed)
P/F: FRONT 2 ENTER
P/F:FRNT2>CURRNT ↓
P/F:FRNT2:FORM#1 ↓
P/F:FRNT2:FORM#2 ↓
P/F:FRNT2:FORM#3 ↓
P/F:FRNT2:FORM#4 ↓