Genicom 3850 User Manual
Page 67
63
DC1/DC3 Control
Y
: The printer will respond to a received DC1/DC3, which causes the printer to be
selected/deselected. If the printer is deselected, the LCD will show STAND BY until DC1 is
received or until you put the printer
ON LINE
by depressing the
ON LINE
key once.
N
: Received DC1/DC3 ignored.
PAR: RCV DC1/DC3
ENTER
PAR:DC1/DC3>Y
↓
PAR:DC1/DC3:N
↓
Init Signal
Y
: Enables parallel interface INIT signal to reset printer.
N
: Disables parallel interface INIT signal.
PAR: INIT ENABLE
ENTER
PAR:INIT ENBL>N
↓
PAR:INIT ENBL:Y
↓
Fault Lead
NONE
: Printer does not indicate activity on Fault lead
ONLN
: Printer indicates ON LINE status on Fault lead.
FAUL
: Printer indicates fault status on Fault lead.
PAR: FAULT LEAD
ENTER
PAR:FAULT>NONE
↓
PAR:FAULT:ONLN
↓
PAR:FAULT:FAUL
↓