Genicom 3850 - Manual (Page 50)

46
Auto Carriage Return
If the printer receives a command (LF) from the host to perform a line feed then the
printer will (Y) or will not (N) append a carriage return based upon your selection.
ANS: AUTO CR ENTER
ANS:AUTO CR>N ↓
ANS:AUTO CR:Y ↓
Prime on Delete
If the printer receives a command (DEL) from the host, then the printer will (Y) or will not
(N) perform a prime (reset) based upon your selection.
ANS: PRIME ON DEL ENTER
ANS:PRIME ON>N ↓
ANS:PRIME ON:Y ↓
Control Codes in Dot Graphics
If the printer receives a control code from the host while in dot graphics mode, then the
printer will (Y) or will not (N) respond to the particular control code based upon your
selection.
ANS: CONTRL IN DG ENTER
ANS:CTRL DG>Y ↓
ANS:CTRL DG:N ↓