Printing the self test – Genicom 3850 User Manual
Page 120
116
P
P
r
r
i
i
n
n
t
t
i
i
n
n
g
g
t
t
h
h
e
e
S
S
e
e
l
l
f
f
T
T
e
e
s
s
t
t
To determine any printer setting, and to check if the printer is working well, print the self-test.
Proceed as follows:
1. Press the
ON LINE
key to disable the printer. The
ON LINE
led should go out and the LCD
displays:
OFF LINE
2. Press the
MENU
key to enter the Operational Menu. The LCD displays:
OPERATIONAL MENU
3. After a time out of a few seconds, the first menu item is displayed:
FONT STYLE
4. Now, press the
↑ key until the LCD displays:
TEST MODE
5. Press the
ENTER
key. The display shows:
TEST:PAPER WIDTH
6. Press the
ENTER
key and then use the
↓ key to select the desired print width based upon the
type of paper which you loaded. Push the
ENTER
key to save your selection. The LCD
displays:
TEST:START TEST
7. Press the
ENTER
key, then the
↓ key. The display shows:
TEST:START:N
8. Press
↓ to change LCD display to read:
TEST:START:Y
9. Press the
ENTER
key and the test pattern will begin printing.
10. To stop the test printing and to exit test mode, press the
ON LINE
key.