Intel 80C188XL - Manual (Page 213)

INTERRUPT CONTROL UNIT
8-18
Figure 8-9. Priority Mask Register
8.4.5 In-Service Register
The In-Service register has a bit for each interrupt source. The bits indicate which source’s inter-
rupt handlers are currently executing. The In-Service bit is set when an interrupt is acknowl-
edged; the interrupt handler must clear it with an End-of-Interrupt (EOI) command. The Interrupt
Control Unit uses the In-Service register to support interrupt nesting.
Register Name: Priority Mask Register
Register Mnemonic: PRIMSK
Register Function: Masks lower-priority interrupt sources
Bit
Mnemonic
Bit Name
Reset
State
Function
PM2:0 Priority
Mask 111 Defines a priority-based interrupt mask.
Interrupts whose priority is lower than this value
are masked.
NOTE: Reserved register bits are shown with gray shading. Reserved bits must be written
to a logic zero to ensure compatibility with future Intel products.
A1216-A0
15 0
P
M
0
P
M
1
P
M
2