Troubleshooting the mx480 mpcs – Juniper Networks MX480 User Manual

Page 180

Advertising
background image

user@host>

show chassis fpc pic-status

Slot 0 Online DPC 40x 1GE R
PIC 0 Online 10x 1GE(LAN)
PIC 1 Online 10x 1GE(LAN)
PIC 2 Online 10x 1GE(LAN)
PIC 3 Online 10x 1GE(LAN)
Slot 1 Online MX FPC Type 3
PIC 0 Online 1x OC-192 SONET
PIC 1 Online 1x OC-192 SONET
Slot 2 Online MS-DPC
PIC 0 Online MS-DPC PIC
PIC 1 Online MS-DPC PIC
Slot 3 Online MPC Type 2 3D EQ
PIC 0 Online 1x 10GE XFP
PIC 1 Online 1x 10GE XFP
Slot 4 Online MPC 3D 16x 10GE
PIC 0 Online 4x 10GE(LAN) SFP+
PIC 1 Online 4x 10GE(LAN) SFP+
PIC 2 Online 4x 10GE(LAN) SFP+
PIC 3 Online 4x 10GE(LAN) SFP+

For further description of the output from the command, see the Junos OS Operational
Mode Commands.

Related

Documentation

MX480 Flexible PIC Concentrator (FPC) Description on page 16

Replacing an MX480 PIC on page 199

Maintaining MX480 PICs on page 134

MX480 PIC Serial Number Label on page 321

Troubleshooting the MX480 MPCs

Problem

The MPCs are not functioning normally.

Solution

Monitor the green LED labeled

OK

above the MPC on the craft interface as soon as an

MPC is seated in an operating router.

The Routing Engine downloads the MPC software to it under two conditions: The MPC
is present when the Routing Engine boots Junos OS, and the MPC is installed and
requested online through the CLI or push button on the front panel. The MPC then runs
diagnostics, during which the

OK

LED blinks. When the MPC is online and functioning

normally, the

OK

LED lights green steadily.

Make sure the MPC is properly seated in the midplane. Check that each ejector handle
has been turned clockwise and is tight.

Check the

OK/FAIL

LED on the MPC and

OK

and

FAIL

line card LEDs on the craft

interface. When the MPC is online and functioning normally, the

OK

LED lights green

steadily.

Issue the

show chassis fpc

command to check the status of installed MPCs. As shown

in the sample output, the value

Online

in the column labeled

State

indicates that the

MPC is functioning normally:

user@host>

show chassis fpc

Copyright © 2013, Juniper Networks, Inc.

156

MX480 3D Universal Edge Router Hardware Guide

Advertising